Genesis OPAL Mast Sizes and Lifting Heights

The mast size required for a particular site is determined by the vertical travel required between the upper and lower landings. When the site is measured, the lift height “H” is always defined as the distance from the lower mounting surface of the lift to the finished floor of the upper landing as shown in the diagram below. If the lift is to be mounted directly on the floor of the lower landing and an entry ramp is used, then “H” equals the elevation change between the upper and lower landings. If the lift is pit mounted, then the measurement “H” is 76mm (3”) greater than the elevation change between landings.

Based on the measured value of “H” the drive mast is selected as follows;

Mast Size	Maximum Lifting Height	Mast Structure Height
GVL-42	1143mm (45")	1737mm (68 3/8")
GVL-60	1600mm (63")	2194mm (86 3/8")

Lifting height = distance between upper landing & lower landing mounting surface (pit or floor)

The standard width of all masts is 980mm (38 5/8")

For more information, please download the Genesis OPAL Design and Planning Guide or contact your local authorized Garaventa dealer.

	CAD BLOCKS Metric Imperial
	LOADING DIAGRAM
	SPECIFICATIONS
	PLANNING GUIDE
	PHOTOS
	BROCHURE
	COMPARISON CHART

Genesis OPAL Mast Sizes and Lifting Heights

Mast Size

Maximum Lifting Height

Mast Structure Height

Genesis OPAL
Resources

Contact Us

Back to General Information Site

Genesis OPAL Mast Sizes and Lifting Heights

Mast Size

Maximum Lifting Height

Mast Structure Height

Genesis OPALResources

Contact Us

Back to General Information Site

Genesis OPAL
Resources